breading applicator (modle,SXJ-400) maintenance

- Oct 30, 2017 -

MAINTENANCE

1. GENERAL

-When working on the electrical ciecuit, switch off and disconnect the supply voltage.

-First of all ,remove an disconnect the power supply for any maintenance work which has to be carried out on the machine with the protective covers removed.

-Replace damaged or broken safety devices immediately .Never electrically bypass the automatic safety devices.

-Regularly cheek the presence and readability of the pictograms on the machine .Take any steps which may be necessary .A diagram of the pictograms used is recorded in the appendices.

-Regularly check all moving and turning parts for wear ,and replace if necessary.

Consult the supplier of lubricating agents for safety leaflets. These publications give information about safe working, health and environmental regulations, procedures to be followed in the event of disasters etc.

 

MACHINE PARTS

MONTHLY SPECTION

LUBRICATION

WIRE BELT

 

◆Check the wire belt for damage.

If slightly damaged. the mesh can

perhaps be bent back into shape. If

a larger section is damaged, then it

should be replaced.

If the belt is worn.,(not smooth, edges protrude upwards) then fit a new belt.

◆If necessary, the belt can be shortened by removing a section.

 

 

 

 

Not applicable.

ROLLS


◆Check for damage/wear. Replace if

necessary.

Not applicable.

CHAIN WHEELS


◆Check the retaining device on the axle. If necessary, tighten the adjusting screw.

◆Check the play in the axle in relation

to the chain wheel. If necessary, re-

place the chain wheel.

◆Check the wear on the teeth. If necessary. replace the chain wheel.

 

 

 

Is lubricated by the chain

CHAINS


◆Check tension. If necessary, readjust.

◆Check for wear and smooth running

Replace if necessary.

When replacing the chain replace the

chain wheels at the same time.

Lubricate.

Grease type: A chain grease with an outstanding resistance against

(being washed away by)water

Lubrication

interval:

monthly

ELECTRICAL PARTS


◆Check for damage. Replace if necessary

 

Not applicable.

BEGE STROTER

VARIATOR


◆The variator/worm wheel reduction gear Should be checked regularly for the following:

◆Check securing bolts and tighten as

necessary.

◆Check alignment.

◆Check reductor ventilation.

◆Remove adhered dirt from the drive

as necessary due to the amount of

heat being discharged (pay particular attention to the motor cooling fins).

◆Check for leakage.

◆Check oil level when idle.

The oil level must be at the halfway

point in the level gauge. Add oil if necessary

 

Change the oil after every 2,000 hours of operation.

Before adding new oil. clean

The variator with a flushing oil.

 

 

Lifetime lubrication before 30,000 hours. When replacing the lubricant thoroughly clean the casing.


Related Industry Knowledge

Related Products

  • Meat Shredding Machine
  • Flour Applicator
  • Fish Fillets Automatic Battering Coating Machine
  • Seafood Tempura Battering Coating Machine
  • Commercial Industrial Beef Chicken Breast Fried Steak Electric Meat Tenderizers Machine
  • 500-800 Kg/h Crispy Chicken Leg Wing Processing Line